Event - gigamedia GGM DVR16RW Mode D'emploi

4.2.4. EVENT

4.2.4.1. MOTION
4.2.4.2. SENSOR
4.2.4.3. VLOSS
www.gigamedia.net
Event works when event in menu was selected at first, so you should
set recording schedule to record a event and then set Record mode to
EVENT: SETUP, RECORD, MISC, REC MODE, EVENT
• MOTION-AREA – Set the area to detect motion.
ALL – Select the whole area.
PART – Select a block.
Selection is done by toggle system through button of remote
controller / front button or drag of mouse
CLEAR ALL – Cancel the whole area.
• SENSITIVITY – Set the sensitivity of motion detection.
Sensitivity degree : 0 < 1 < 2 < ..... < 9
• ALARM-OUT – Set the alarm-out when motion is detected.
• NIGHT MODE – Set different sensitivity for day time and night time.
(This option can be used in order to avoid false motion event caused by
camera noise at night)
• NIGHT TIME – Night time can be designated individually by each operator.
• RECORD – Select channel to record if you want to record the data
with sensor activation.
• TYPE – Select sensor type to match sensor type you have.
• ALARM-OUT – Set the alarm-out when a sensor is activated.
If you set the Alarm-out to port1, alarm will ring when video-loss
occurs in a channel.
It makes alarm-out with video-loss.
EN
67