gigamedia GGM DVR16RW Mode D'emploi page 54

3.3.3. Other Icons
EN
3.3.3.1 HDD STATUS
It indicates capacity of HDD, the percentage show the usage of HDD.
3.3.3.2. SCREEN SHOW STATUS
You can select how screen will display.
In Live MODE, there are several modes ; PIP, POP, Sequence, Quad, 7, 9, 10, 16ch mode.
But the 7, 9, 10, 13, 16 cannot operate in 4ch DVR.
In play mode, there are 3 modes : Quad, 9, 16.
Also, only quad mode can be operated in 4 channels.
3.3.3.3. CHANNEL ICON
You can change channel displays on screen. There are 1~4 in 4channels, and 1~16 in 16channels.
3.3.3.4. USB ICON
This Icon will be shown after you attach USB into DVR.
3.3.3.5. NETWORK ICON
This Icon will be shown while someone access DVR through Network with CMS, or Web-viewer.
3.3.3.6. REMOTE CONTROLLER ID ICON
This Icon will be shown if you set up system ID in system sub-menu.
The color of number of Remote control Icon will be changed to "Yellow" in case that status is active,
that is the number of remote controller matches the number of system ID.
Otherwise, the color will be changed to "RED".
If you click Remote control ID Icon, you can see the below :
- Status = Active[ or De-active]
- SYSEM-ID = 01, Request-ID = 01
- Status means that the DVR can be operated or not with the remote controller.
- SYSTEM-ID means the number of remote controller ID of DVR.
- Request –ID means that the number of Remote controller you have got.
If you like to control the DVR with the remote controller, the value of SYSTEM _ID is the same
to that of Request-ID.
Note : You should press two digits when you select System-ID. For example, press 0 + 5, when
you select 05. Don't press only 5.
54
www.gigamedia.net