Device Maintenance - LUND 66904 Manuel D'instructions

GB
that it fi ts the device housing's entire circumference (IV). Connect the device to the power supply by inserting
the power cord plug into the socket. The device is ready for use.
Warning! Never move the device with a fi lled tank.
Using the device
The device has two buttons. The button with "MIST" or "MIST/TIMER" written on it is used to start the emis-
sion of the steam jet. Pressing this button again will switch to the next steam jet emission mode, which will
be indicated by lighting up the mode designation. The "ON" or "CONT" mode means continuous emission of
the steam jet.
WARNING! Do not exceed 6 hours of continuous steam emission. After this time, switch off the device for at
least one hour.
The mode is described by the number and letter H (e.g. 1H) and indicates the number of hours after which the
device will automatically switch the steam emission off .
The "10SEC" mode causes the steam to be emitted in intermittent mode: 10-second emission, and then a
10-second break. During the break, the ultrasonic generator is switched off , but the steam accumulated during
the generator's operation can still escape from the device. This mode is used to reduce the emission of steam
when such intensive humidifi cation is not required.
The device is switched off by pressing the "MIST" or "MIST/TIMER" button several times so that none of the
operating modes are illuminated. The steam emission will be stopped and the quiet hum of the device's fans
will no longer be heard.
The device has a sensor to check whether there is water in the tank. If a lack of water is detected in the tank,
the device will not start the ultrasonic generator.
The "LIGHT" button turns on the backlight and allows to control it. The fi rst press of the button activates the
automatic backlight colour change mode, the next press stops the automatic backlight colour change and
leaves the backlight in the selected colour. The next press of the "LIGHT" button changes the intensity and
colour of the backlight. The backlight is switched off by pressing and holding the "LIGHT" button until the
backlight is switched off .
Remote control operation
The remote control is powered by a battery whose type and method of replacement is shown on the remote
control housing. Aim the front of the remote control at the device approximately where the device buttons are
located, and then press one of the buttons. There must be no obstacles between the remote control and the
device which would obstruct infrared radiation.
The ON/OFF button is used to turn the device on and off .
The "Intermittent" button starts the intermittent operation of the device: 10 seconds of steam emission, and
then a 10-second break. During the break, the ultrasonic generator is switched off , but the steam accumulated
during the generator's operation can still escape from the device. This mode is used to reduce the emission of
steam when such intensive humidifi cation is not required.
The "Continuous" button described starts the continuous steam emission mode.
The "Timing" button starts the mode in which the device emits steam for a certain period of time and then
switches off . The selected time is indicated by backlighting the description of the selected mode on the de-
vice's housing.
The "Big/small" button allows to select the intensity of the steam jet.
The "Light" button allows to turn on the backlight and control it. The operation is the same as using the button
located in the device's housing.

DEVICE MAINTENANCE

Caution! All maintenance works must be carried out with the device's electric power supply disconnected. Pull
15
O R I G I N A L I N S T R U C T I O N S