Art. 5515735 (Fig. 5) - Malossi TC UNIT O2 CONTROLLER Mode D'emploi

Émulateur lambda
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

any malfunctioning of the system
(Fig. 4).
Art. 5515735
(Fig. 5)
• Locate the Lambda sensor and
follow its cable until you reach
its connector.
• Disconnect the connector
insert, into the circuit, the O2
controller (Fig. 5).
Attention:
screw the ground ring
terminal to the throttle body (7),
hence avoiding any malfunctioning
of the system (Fig. 5).
Art. 5514746
(Fig. 6)
• Locate the Lambda sensor
follow its cable until you reach
its connector.
• Disconnect the connector and
insert, into the circuit, the O2
controller .
• Disconnect the injector connector
(9); insert, into the circuit, the O2
controller (Fig. 6).
Attention:
screw the ground ring
(10)
terminal
to the throttle body,
hence avoiding any malfunctioning
of the system (Fig. 6).
Art. 5514747 - 5514749 -
5514750 - 5519172B - 5515785
- 5515786 - 5516341B
• Locate the Lambda sensor
and follow its cable until you reach
its connector (12).
• Disconnect the connector and
insert, into the circuit, the O2
controller (Fig. 7).
NB: Position the lambda emulator
taking care that the wires will not be
damaged by vibrations or heat.
Art. 5516458
• Locate the lambda sensor
(6)
and
• Follow the lambda cable until you
• Disconnect the connector and
• Disconnect the injector connector
• Apply the splice, supplied in the
(8)
and
• Connect the red wire
Warning:
connected to the electrical tap
connector we suggest to tape the
wire bunch, to avoid electrical tap
vibrations damaging the wires.
• Please connect the eyelet to the
Art. 5517530B
(Fig. 7)
- Fig. 12)
(11)
• Locate the lambda sensor
• Follow the lambda cable until you
7
(Fig. 8 - Fig. 9)
(Fig. 8)
the vehicle head
reach its connector
insert, into the circuit, the O2
controller
(15) (Fig. 9)
Malossi kit, to the white/black wire
that exits the connector on the
injector
comes from the CDI to the
electrical tap connector
(Fig. 9)
once the faston is
ground node
(17)
located on the
crankcase (Fig. 8).
(Fig. 10 - Fig. 11
the vehicle exhaust piper
reach its connector
(13)
on
(14)
(18)
which
(16)
(10)
on
(Fig. 10)
(20) (Fig. 11)

Publicité

Table des Matières
loading

Table des Matières