Intended Use - SEVERIN WK 3418 Mode D'emploi

Intended use

∙ The appliance must only be used for
heating clean, fresh water.
∙ Any use other than that described in
these instructions (misuse) must be
considered improper and may lead to
personal injury or material damage.
∙ This appliance is intended for
domestic or similar applications, such
as
- in staff kitchens in shops, offices and
other similar working environments,
- in agricultural working environments,
- by customers in hotels, motels etc.
and similar accommodation,
- in bed-and breakfast type
environments.
∙ Do not leave the appliance unattended
while connected.
In case of a defective appliance
A defective appliance can cause
material damage and injury:
∙ Check the appliance for damage
before every use. Do not operate if the
appliance shows any sign of damage.
∙ In the event that you detect damage,
please contact our customer service
department by phone or email (see
appendix).
∙ Repairs to this appliance or its power
cord must only be carried out by our
customer service.
Overview and parts included
1. Lid
2. Lid opener
3. Control panel
4. Water container
5. Handle
6. Power cord with plug
7. Base
12
8. Rating label (on underside)
Control panel
9. Temperature button
10. On/Off button
11. Selector button Keeping-warm / Heating-up
12. Display
Before using for the first time
∙ Unpack the appliance completely and remove all
packaging materials.
∙ To clean the kettle, boil and discard the first filling of
water.
Thermal safety cut-out
The pre-set thermal safety cut-out protects the heating
element from overheating should the appliance be
erroneously switched on without any water, or if the heating
plate is calcified. If the safety cut-out has been activated,
the appliance cannot be switched on again. In such a case,
the appliance must be allowed to cool down, or must be
descaled, before it is switched on again.
Temperature selection
The temperature can be selected using the Temperature
button on the
∙ The current water temperature in the container
(≥ 20 °C) is shown on the display.
∙ Pressing the Temperature button
increases the temperature selection in 5-degree steps.
∙ If the current temperature inside the container exceeds
the temperature selected, the appliance cannot be
started; in this case, a sequence of three beep signals
is heard.
∙ Temperatures below 40 °C cannot be selected.
Automatic switch-off
Unless the keep-warm function has been selected, the
display will switch off automatically around 3 minutes after
the last operation.
In the keep-warm mode, the kettle switches off after around
30 minutes.
Operation
∙ Remove the water container from its base and press the
lid opener to open the lid.
∙ Fill the container with water to the desired level,
observing the Min (0.5 l) and Max (1.7 l) markings.
∙ Close the lid and place the container back on its base.
∙ Insert the plug into a suitable wall socket.
∙ A beep signal is heard and the display shows C,
followed by the current water temperature inside the
container. The appliance is now in Stand-by mode.
∙ Use the Temperature button
temperature.
∙ Confirm by pressing the On/Off button
level indicator lights up blue. The display shows
the selected temperature, followed by the current
repeatedly
to set the desired
. The water