Technical Parameters - LUND 67091 Notice Originale

Table des Matières

Les langues disponibles

disconnect the brush, pipe and hose and proceed with maintenance.

Disconnect the dust container from the vacuum cleaner. Open the lower cover of the container and discharge the waste collected

in the container. Open the top cover, remove both ﬁ lters. Clean the container with a damp, soft cloth, then dry with a dry cloth or

allow to dry.

Remove the sponge ﬁ lter from the upper ﬁ lter and wash it under a stream of running, lukewarm water, squeeze out excess water

and leave the sponge to dry completely. Wait at least 24 hours after placing the ﬁ lter in a well-ventilated place at room temperature.

Warning! It is forbidden to use the vacuum cleaner with a wet or damp ﬁ lter. This can result in an electric shock.

The bottom ﬁ lter can be rinsed under running, lukewarm water. Next dry with a dry cloth and allow to dry completely. Wait at least

24 hours after placing the ﬁ lter in a well-ventilated place at room temperature.

Open the outlet ﬁ lter cover by pressing the lock button (XIII). Remove the ﬁ lter, the dirty ﬁ lter can be washed under running,

lukewarm water or replaced with a new one. After cleaning, dry the ﬁ lter thoroughly before reassembly. Wait at least 24 hours

after placing the ﬁ lter in a well-ventilated place at room temperature. Check the ﬁ lter seal for damage. Replace the ﬁ lter with a

defective seal with a new one.

Install the ﬁ lter as shown in the illustration (XIV). Secure the ﬁ lter by attaching and snapping on the cover.

Do not wash ﬁ lters in mechanical dishwashers and do not dry them with a stream of hot air. This can cause deformation of the

plastic material used for the construction of the ﬁ lter. Avoid exposing the ﬁ lters to direct sunlight.

No other part of the vacuum cleaner must be exposed to water. The non-woven part of the upper ﬁ lter should be gently tapped,

shaking oﬀ larger impurities. In the case of excessive contamination, replace the ﬁ lter with a new one.

Clean the remaining parts of the vacuum cleaner with a cloth slightly soaked in water, then dry or allow to dry.

Store the vacuum cleaner in a horizontal position. During storage, ensure that the hose is not bent, crushed or otherwise de-

formed. The hose can be connected or disconnected from the vacuum cleaner for storage. The vacuum cleaner has a hook at

the rear for attaching the ﬂ oor and carpet brush (XV) for storage. Store the vacuum cleaner with the power cord rolled up and its

plug disconnected from the socket.