Télécharger Imprimer la page

Lavorwash DYNAMIC A4 Mode D'emploi page 36

Publicité

First set of operations:
Wash the floor as described in paragraph 7.11
without drying the floor
Allow the detergent solution to work on the
dirty floor according to what is indicated in
the information relative to the detergent
used.
Second set of operations:
Proceed as explained in the previous "Direct Wash-
ing" paragraph (7.13.3) to also proceed with drying
the floor.
☞ Never use the machine without the detergent
solution: the floor might be damaged.
7.13.5 POST-SCRUBBING OPERATIONS
Close the detergent solution outlet.
After having completely dried any traces of water
on the surface, wait a few seconds and then lift the
squeegee and turn off the suction motor.
Move to a suitable location to drain the tanks;
empty and clean the tanks (see 7.10).
it from the control panel.
If necessary, charge the battery (see the relative
section).
7.14
SPECIFIC INSTRUCTIONS FOR THE
USE OF MODEL AC 230V
The AC 230V machine may be turned on only if
the voltage indicated on the tag corresponds with
the available voltage and that the electrical outlet
is grounded (earthed).
Do not damage the feed cable; do not crush or
pull on it.
Do not run over the feed cable with the machine.
The cable could wind up in moving parts causing
a short circuit.
• ATTENTION - The AC 230V machine has
parts, which are connected to the current;
contact with these could cause grave injuries
or even death.
- Before executing any type of operation on the
machine always disconnect it from the electrical
source.
- Never touch electric cables that are defective or
worn.
- Before gaining access to the electrical system it is
always necessary to disconnect the machine from
the electrical source.
- In the case of defective, damaged, or cracked
electric cables, replace immediately with authentic
replacement parts.
- The network of connections must be protected
from water spray.
- The patch cord for the connection of the
machine to the mains power must conforms
to current safety rules.
- The electrical system to which the machine is
connected must be equipped with a cutout box.
- It is absolutely forbidden to use the machine in
proximity to swimming pools or stretches of water.
• EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from
the power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not
be put into operation until a technician authorized
by the manufacturer has examined it.
8. MAINTENANCE
MAINTENANCE INFORMATION
• Switch OFF the ON-OFF main switch, and Dis-
connect the Anderson connector of the battery wir-
ing from the Anderson connector of the machine
wiring (Foto B-17*)(Foto B-18*).
☞ All work on the electrical system as well as all
maintenance and repair operations (especially
those not explicitly described in this manual)
should be carried out only by authorized service
centers or by specialized technical personnel who
are experts in the sector and in the pertinent safety
regulations.
Performing regular maintenance on the machine,
and carefully following the manufacturer's instruc-
tions, is the best guarantee for obtaining the best
performances and extended machine service life.
8.1
TANKS
Drain the two tanks as described in the relative
sections.
Remove any solid dirt by filling and draining the
tanks until all dirt has been eliminated: use a wash-
ing hose or similar tool to do this.
• Water hotter than 50°, a high-pressure
cleaner or excessively powerful sprays may
damage the tanks and the machine.
Leave the plugs of the tanks open (only while the
machine is not being used) so that they can dry
and thus prevent the formation of foul odors.
8.2
SOLUTION FILTER CLEANING
Remove the transparent cap (Foto E-36*) then re-
move the metal strainer.
Clean them, reinstall the metal strainer in its seat
and close the water filter screwing the transparent
cap.
8.3
SUCTION HOSE
Detach the suction hose from the squeegee (Foto
H-27*) . Now you can wash the hose and remove
any obstructions.
36

Publicité

loading