X-METAL 6086 Manuel D'instructions page 43

Maintenance
In a timely manner the centralizer skeleton.
1.If the ground not level off, loose soil layer thickness is differ, Aluminum carport may tilt to one end, once found,
should be timely the centralizer, in case of deformation. The shed may be slant when facing the un-level ground
or loose soil layer, please righting the shed urgently to avoid deformation.
2.Prevent increased loading-weight artificially. Don't let any lentils, towel gourd, pumpkin and climbing
fruits and vegetables to grow up on the canopy, otherwise if it is windy and rainy, skeleton is unbearable,
and easy to cause skeleton crack, broken, collapse Avoid kinds of vine plant climbing on the canopy, or
it can not bearing for the wind and heavy rain, broken,collapse may accured.
The sunshine board maintenance
1.IIn the using canopy, note do not use sharp objects collision films, avoid to cut films. Be careful not collide with
a sharp object films,in order to avoid scratched films when using.
2.If films appear rupture, can use glue to repair or repair with transparent tape. Available polyurethane adhesive
for repairing. Often keep the films clean, generally the PC sheet replacement using 6 ~ 10 years later, so as not
to affect the light transmittance. Using transparent tape adhesive to patch cracks of film when any broken in case.
Keep clean films,it will better replaced by new panels after 6-10years to avoid affect the Light transmittance.
3.The flame retardant in polycarbonate material, but still need to stay away from fire, avoid softening deformation.
As Polycarbonate is fire-retardant materials, please stay away from the fire, to avoid softening deformation.
Frame maintenance
1.The frame is aluminum alloy structure, if there is a white problem can wipe with a cloth in time, under high temperature and wet
environment. All frames are made of alloy aluminum. White spots may appeared under wet-hot environment, just wipe it.
2.If there is any distortion calibration shall be carried out in a timely manner in order to avoid sunshine board out, If Polycarbonate out
of frame, please removed screws. Carried out in accordance with the manual installation steps, and partial restoration.Any distortion
calibration shall be carried out in a timely to avoid the sunshine board fall off.
3.If connection piece serious rust, should change in time the new screws and connectors to ensure connection parts are firm.
Please replaced the serious rust screws and connection for stable.
How to do in bad weather?
1.If there is lightning may not stay in the shed, because aluminum alloy skeleton is conductive and will be caused serious consequences.
Do not stay under shed when lightning.
2.Wind power reaches 70 km/h should be prepared ready to defense equipment, fixed Aluminum carport. Fixed method with a strong rope
or cable connect the cornice work four Angle of anchor block inserted into the soil or tied in a nearby tree stem > 10 cm in diameter. Pay
attention to theweather turns good dismantled after the rope or cable to avoid injury and pedestrian. Please get defensive measures when
facing heavy wind (abt 70km/H). Reinforce by steel rope and anchors which insert into ground or Strapping on a big tree.
3.Clear in time at the top of the deciduous leaves led to the decrease of the canopy transparency, heat preservation effect is reduced
To avoid greenhouses reduced transparency, heat preservation effect is reduced, please clean up the leaves at the top.
4.During snow, removal work in time, if not timely to snow removal, Use solid wooden plate supporting internal intermediate point and middle
position of polycarbonate, prevent snow collapsing the Aluminum carport. To prevent collapsing by snow, please remove the snow in time,
Or support by a wooden stick support in the center of the sunshine board for reinforcement.
-43-