Assembly And Installation - Uline H-6502 Mode D'emploi

24
25
1. Check to see that all parts are included.
2. Screw telescoping suction tube (23) into threaded
opening at bottom of pump body assembly (6)
using PTFE sealant tape provided.
CAUTION! Do not use pipe sealant.
3. Slide handle assembly (24) over shaft (9) and tighten
it using clinch nut (7).
4. Screw discharge spout assembly (2) into threaded
outlet of pump housing.
PAGE 2 OF 6

ASSEMBLY AND INSTALLATION

10
9
8
7
28
27
26
1 3
2
5
15
6
13
14
12
16
11
17
18 20
19
23
5. Attach nozzle holder (21) to pump body assembly
by removing the 1/4" bolt (18) from pump body
assembly (6) and tightening with nozzle holder in
place.
6. Attach dispensing nozzle (22) to one end of rubber
hose (1). Attach discharge spout assembly (2) to
other end of rubber hose.
7. Fully extend telescoping suction tube (23) and insert
assembled pump through 2" threaded opening of
drum. Once bottom of telescoping suction tube
touches base of drum, screw bung (20) into drum
fitting and tighten.
1-800-295-5510
uline.com
# DESCRIPTION
4
1 Rubber Hose
2 Discharge Spout Assembly
3 Air Release Valve
4 Discharge Spout
5 Adapter
6 Pump Body Assembly
7 Clinch Nut
8 Rod Guide
9 Shaft
10 1/4" Bolt
11 Cover
12 Paper Gasket
13 Vane
14 Rotor
15 Body
16 Spring
17 Graphite Seal
18 1/4" Bolt
19 Pin
21
20 Bung
21 Nozzle Holder
22 Dispensing Nozzle
23 Telescoping Suction Tube
24 Handle Assembly
25 Grip
26 Screw
27 Crank
22
28 Clinch Nut
QTY.
1
1
1
1
1
1
1
1
1
6
1
1
3
1
1
3
1
1
1
1
1
1
1
1
1
1
1
1
0123 IH-6502