turbionaire SMART 8 eco Mode D'emploi page 17

B. Drainage
There are two ways of removal collected water produced by the unit.
1. Manual draining: the water tank is removed manually.
2. Continuous draining: attach a drain hose to the unit so that the condensed water is
drained by using gravity.
C. Emptying the water tank
The unit will shut down once the water tank is full. It will run again once you have emptied
the water tank and reinstalled it properly. When the tank is full, the unit will make a buzzing
sound, and the "Water Full" LED will turns in red
•
Press the POWER button to turn off the unit.
•
Pull on the water tank and slide out of the body of the dehumidifier.
•
Empty the water into an area with a drain or outside.
• Clean the inside of the tank, if necessary, as well as the outside.
•
Replace the empty tank back into the unit.
•
Press the POWER button to restart the unit.
NOTE: If the "Water Full" LED is still on, check if the water tank float is
correctly placed and free from any blocking.
D. Continuous drainage
For continuous operation or unattended dehumidification, please connect the attached
drain hose to the unit. Condensate water drains freely into a bucket or drainage hole by
using gravity. Remove the rubber plug attached to the continuous drain connector from the
back of the device before connecting the hose. Remove the water tank and lock with the
rubber plug removed, the hole on the front of the device, which normally drains the water in
the tank, thus water being directed to be discharged through the rear part to which it
17