Handle Assembly - Chapin 8201A Manuel D'utilisation Et D'entretien

Chapin Spreader Operator's Manual - English
WARNING
WARNING: IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT
IN PRODUCT FAILURE OR INJURIES. FOR SAFE USE OF THIS PRODUCT YOU
MUST READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING.
Do not allow anyone to operate the broadcast spreader without proper instructions. Do not
permit children to operate the broadcast spreader. Wear protective eyewear and gloves when
handling and applying lawn and garden chemicals. Read the chemical label instructions and
warnings for handling and applying the chemicals you plan to spread – application settings
provided are only a guideline.
Auger is designed to work in forward motion. Excessive reverse motion could cause
binding. If resistance is felt while pulling spreader backwards, stop and clear salt
from auger.
Assembly Instructions
Approximate assembly time is 5-10 minutes
Suggested Tools:
Wrench and/or Ratchet Set

HANDLE ASSEMBLY

• Assemble handle to uprights with Hex
bolts and M6 nuts (Figure A).
• Tighten M6 nuts completely.
Note: If you frequently store your spreader with
the handle down, optional thumb screws are
provided for faster disassembling.
Figure A
1E