Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 12

Switch Off
•
To stop the motor, release the power trigger and the lock-off button together.
4.5- Speed control
•
Adjust the rotation speed by turning the speed control dial (6).
"1" – lowest speed
"6" – highest speed
•
WARNING! Ensure the mixer is firmly held by the handles with both hands when
adjusting the speed control dial.
V. OPERATION
5.1- Intended use
This power tool is intended for mixing liquid and powdery building materials such as paint,
mortar, lacquer and similar substances (except flammable materials). DO NOT use for food
mixing. The tool is desigend for indoor domestic use only, but NOT for artisanal, commercial,
professional and / or industrial use.
5.2- Operation
•
Check the paddle assembly is aligned and securely tightened to the spindle, then install a
sufficiently charged Ribimex 20V battery pack onto the tool.
•
Wear appropriate personal protective equipments.
•
Transfer materials for mixing in the mixing container. Ensure the container is placed
securely on level ground.
•
WARNING! DO NOT hold the mixing container with your body.
•
Adjust the speed required in the mixing.
•
Firmly grip the tool with both hands and maintain a balanced and secure body position.
•
Immerse the mixing paddle into the materials, then turn on the tool.
•
Once the mixing work is finished, stop the mixer by releasing both lock-off button and
power trigger.
•
When the mixer is completely stop, raise the mixing paddle out of the mixture.
•
Place the paddle into a bucket of water and run the mixer for few seconds for cleaning.
5.3- Tips
•
For a better mixing result, slowly move the mixing paddle through the mixture during
operation.
•
Materials with high viscosity requires higher torque and should be mixed at slower speed.
•
CAUTION! Avoid the running paddle from touching the mixing container that may result
in kickback.
Fig. 3a Fig. 3b
Page 12 / 20