Getting Started - Ribimex PRBAT20 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging.
•
Check if the product and accessories (if any) are intact.
4.2- Content
•
1 Mixer body
•
1 Mixing paddle head
•
1 Mixing paddle shaft
•
2 Wrenches
4.3- Assembly
WARNING!
Before starting assembly or changing accessories, turn it off and remove the
battery pack.
Installing the mixing paddle
•
Align the paddle head (2) and paddle shaft (3) as illustrated in Fig. 2a.
•
Insert and turn the paddle shaft into the paddle head, then tighten the paddle assembly with
using the provided wrenches.
•
Insert and turn the paddle assembly into the spindle (7), then tighten the paddle with using
the provided wrenches. See Fig. 2b.
•
WARNING! Make sure the parts are in alignment and securely tightened before starting
operation.
4.4- Switch On/Off
Switch On
•
Install the Ribimex 20V battery pack onto the tool.
•
Press the lock-off button (4) with righthand thumb, then pull the power trigger (1) to start
the motor.
Fig. 2a Fig. 2b
Page 11 / 20