Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 10

•
Maintain good housekeeping and sufficient lighting in the working area.
•
Cleaning and user maintenance shall not be made by children.
•
Use attachments/accessories specified by the manufacturer.
•
Perform service maintenance by qualified personnel only.
3.2- Additional safety rules for electric power tool
•
When the tool is not in use or before performing cleaning, turn it off and remove the
battery pack.
•
To reduce risk of injury, keep children and bystanders away while operating this power
tool.
•
Never leave the product running unattended. Operate the tool only when holding by both
hands.
•
Do not overreach. Keep proper footing and balance at all times.
•
Keep handles and grasping surfaces dry, clean and free from oil and grease.
•
Keep hair, loose clothing, finger and any parts of body away from openings or moving
parts.
•
To reduce the risk of electric shock, do not use near water or any liquid.
•
Do not touch with wet hands.
•
Do not expose the tool to rain or wet conditions. Water entering a power tool will increase
the risk of electric shock.
•
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.
•
Maintain labels and rating plate through the life of service.
•
Do not use the power tool if the switch does not turn on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
•
Do not use a power tool while you are tired or under the influence of drugs, alcohol or
medication.
•
Store idle power tool out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool.
•
Do not force the power tool. Use the tool for prescribed purpose.
3.3- Special warnings when using this product
•
Use personal protective equipment. Always wear safety goggles, dust mask, earmuffs,
non-skid safety shoes and safety gloves when using the tool.
•
Do not use the tools in any operations that beyond the intended purpose.
•
Remove any adjusting wrench before turning on the power tool.
•
This tool is not intended for food mixing.
•
Perform the mixing operation with the mixing container placed on a solid and level
ground.
•
DO NOT touch the running mixing paddle or shaft.
•
If the tool falled into the materials to be mixed, remove the battery pack immeiately, then
send to serive dealer for checking.
•
Residual risks: Even when the tool is used as prescribed it is not possible to eliminate all
residual risk factors. The following hazards may arise in connection with the tool's
construction and design:
a) Damage to lungs if an effective dust mask is not worn.
b) Damage to hearing if effective hearing protection is not worn.
c) Health defects resulting from vibration emission if the power tool is being used over
longer period of time or not adequately managed and properly maintained.
d) Health hazard resulting from dusts from materials containing harmful substances.
Page 10 / 20