ASROCK B660M-HDVP/D5 Mode D'emploi page 25

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, 2, No. 19)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Fan Connector
(4-pin CHA_FAN2)
(see p.1, 2, No. 16)
Chassis/Water Pump Fan
Connector
(4-pin CHA_FAN1/WP)
(see p.1, 2, No. 20)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, 2, No. 3)
22
OUT_RET OUT2_L
J_SENSE
MIC_RED
OUT2_R
PRESENCE#
MIC2_R
GND
MIC2_L
1
GN D
+12V
CHA_FAN_SPEED
FAN_SPEED_CONTRO L
1 2 3 4
1
GND
2
FAN_VOLTAGE
3
CHA_FAN_SPEED
4
FAN_SPEED_CONTROL
4 3 2 1
GND
+12V
CPU_F AN_SPEED
FAN_SPEED_CONTROL
This header is for connecting
audio devices to the front
audio panel.
Please connect fan cable to
the fan connector and match
the black wire to the ground
pin.
This motherboard
provides a 4-Pin water
cooling chassis fan
connector. If you plan to
connect a 3-Pin chassis water
cooler fan, please connect it to
Pin 1-3.
This motherboard provides
a 4-Pin CPU fan (Quiet Fan)
connector. If you plan to con-
nect a 3-Pin CPU fan, please
connect it to Pin 1-3.