Opale-Paramodels Mike XL Mode D'emploi page 19

Position the bearing supports. The bearings must be
in opposition with the sides (to be checked with the
shoulder of the bearing)
Position the front plate on the two parts comprising
the inner bearings then secure it to the side using a
CHC 4x12 screw and M4 lock nut.
Perform the same operation on the other side by
symmetry.
Here as an option, the mounting of the accelerator
servomotor.
It is recommended to use an OPS2920AHV or OPS-
3520BLS servo motor.
The 2nd slot can also be used for the accelerator, it
can also be used to perform the "ears" on your wing.
Mount the actuator using 4 CHC M3x10 screws and
M3 lock nuts.
O pal e - Pa ramo del s. co m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
19
contact@opale-paramodels.com +33(0)981 144 387