Hamilton Beach Penguin Utilisation Et Entretien page 3

HOW TO USE YOUR CAN OPENER
1. Place can opener on level surface.
2. Plug cord into electrical outlet.
3. For first time use, push front of cutting
assembly to lift blade. See Figure 3.
4. Make sure that flip-up magnet is in the
up position. Tilt top of can in, to position
cutting blade inside rim of can.
5. Push down top of cutting assembly.
6. The motor will begin turning can and
cutting lid. (It is not necessary to hold
the cutting assembly down or to hold
the can during the cutting action, unless
opening large or heavy cans.)
7. The motor will automatically stop when
the can is open.
8. Hold can and push front of cutting
assembly to release can. See Figure 4.
Figure 3
Figure 4
4
HOW TO CLEAN YOUR CAN OPENER
1. Unplug cord from electrical outlet.
2. To remove cutting assembly, turn
release button clockwise. See
Figure 5. Then remove cutting
assembly.
3. Wash cutting assembly in hot, soapy
water. Rinse and dry thoroughly.
4. Or remove flip-up magnet and place
the cutting assembly in automatic
dishwasher. To remove magnet,
grasp one side near hinge and pull
out slightly. See Figure 6. This will
release the magnet from the hinge.
Hand wash flip-up magnet.
5. Wipe body of can opener with damp
cloth. NEVER immerse the can
opener in water.
6. To reassemble, place cutting assem-
bly into position and firmly press
both sides until the unit snaps into
place. See Figure 7. Replace
magnet if it was removed.
Figure 5
Figure 6
Figure 7
5