Reer 1912 Mode D'emploi page 9

STARTING UP:
Switch setting:
Caution:
You should start up the device before the first use with a good ventilation of the room of
approx. 10 minutes. During the first start-up the device could cause odor accumulation.
DO NOT TOUCH the radiant heater during and shortly after use! (HEAT RADIATION)
Plug the heater into the socket-the heater is now ready for use
Caution: Do not place the power cord over the radiant heater!
• The local electrical regulations (EVU) must be complied with when installing the heater in
bathrooms and shower rooms. The heater must be positioned so that the pull switch
cannot be directly touched from the bathtub or shower.
• Device must not be installed above bathtub!
The device should not be used by children or people having physical, sensory or mental
limitations. People having insufficient experience and/or knowledge should be supervised
and instructed in order to guarantee the secure use of the device.
Cleaning:
Before cleaning is begun, please ensure that the device is
switched off and cooled down (draw the plug).
Clean the surface with a dry or damp cloth.
The reflector and heating bar can only be cleaned by an expert.
Repair:
The device may only be repaired by an expert.
0 OFF
1 300W The red LED glows
2 600W The red LED glows
9