Connecting The Power Supply; Securing The Refrigerator - Dometic RC10 4S 70 Serie Instructions De Montage

Installing the refrigerator
3.3

Connecting the power supply

A
NOTICE!
• The electrical installation and repairs may only be performed by a
specialist in accordance with the applicable national regulations and
standards.
• To avoid voltage loss and therefore a drop in performance, the cable
should be kept as short as possible and should not be interrupted if
possible. For this reason avoid additional switches, plugs or power
strips.
• Before connecting check whether the operating voltage and the
battery voltage correspond (see type plate).
➤ Determine the required cross section of the cable in relation to the cable length
according to fig. 4, page 5.
➤ Connect the cables to the AMP connector of the refrigerator (fig. 5, page 6).
➤ Connect the other ends of the cables to the
A
NOTICE!
• Make sure the polarity is correct.
• Fit the positive (+) cable with a 10 A fuse.
– as directly as possible
– rd (red): with a fuse protection (10 A) fitted to the positive (+) pole
– bk (black): to the negative (–) pole
3.4

Securing the refrigerator

!
WARNING! Fire Hazard
• When positioning the device, ensure the supply cord is not trapped
or damaged.
• Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the device.
!
CAUTION!
Only screw through the bushings provided, otherwise foamed
components, such as cables, can be damaged.
16
RC(S)(L)(D)10-Series
power supply:
12 Vg
EN