GB
IMPORTANT SAFETY INSTRUCTIONS, SAVE THESE INSTRUCTIONS:
- Failure to install and operate the
damage to the
charger
- Working in the vicinity of a lead-acid battery is dangerous, batteries generate explosive gases
during normal battery operation. For this reason it is of the utmost importance that each time
before using the
charger
- To reduce the risk of battery explosion, follow these instructions and those marked on the
battery.
- To reduce the risk of injury, charge only lead-acid, AGM, Lithium or gel batteries (be sure that
the selected charging curve is suitable for the type of batteries that have to be charged). Do
not attempt to charge any other type of chargeable or non-chargeable battery; these batteries
may burst, causing personal injury and
- Lead-acid batteries produce internal explosive gases during charging: prevent flames and
sparks and provide adequate ventilation.
- Study all battery manufacturer's specific precautions such as removing cell caps while
charging and recommended rates of charge.
- Never place the
charger
from the battery will corrode and damage the
- Do not expose the charger to the rain. For indoor use only.
- The power supply unit/battery charger must be connected by qualified personnel only.
- Connection to the mains power supply must be carried out to national installation regulations
- Do not connect the device to mains voltage different from nominal value
- Before connecting the power supply unit/battery charger to a generator, make sure the voltage
produced is stable.
- Do not carry out maintenance without disconnecting from the 230V mains.
- Disconnect the power supply before connecting or disconnecting the battery connection.
- A minimum of 30mm clearance should be provided at each end of the charger. Install the
battery charger in a dry and well aired place. Do not obstruct the air vents on the lid.
- Charger surface may be hot while plugged in and for a period of time thereafter.
- Do not attempt to open the charger. There is risk of electric shock even if the charger is
unplugged. No user serviceable components inside.
- Do not alter the device or the cabling of battery charger.
- If the cables or output connectors are damaged contact the service center.
- For the charging of automobile batteries:
- The battery terminal non connected to the chassis has to be connected first. The other
connection is to be made to the chassis, remote from the battery and fuel line. The battery
charger is then to be connected to the supply mains.
- After charging, disconnect the battery charger from supply mains. Then remove the chassis
connection and then the battery connection.
- This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
- The alternative format manual can be requested by e-mail: assistenza@nordelettronica.it.
charger
in accordance with these instructions may result in
or injury to the operator
, you read and follow the instructions provided exactly.
damage.Never charge a frozen battery.
directly above or below the battery being charged; gases or fluids
charger
GB