Maclaren techno xlr buggy Manuel D'instructions page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9
REMOVING AND REFITTING THE SEAT COVER
Remove hood from buggy if fitted.
Using foot, lift the break pedal, then press down on the
lever sticking out on the right side of the frame.
A Twist shoulder strap end buckles and feed through holes.
B The waist harness back strap is fixed to the chassis
behind the seat. To remove, twist the buckles on each
end of the harness back strap and unthread from the
'D' rings attached to the chassis.
NOTICE: It is important that the strap be rethreaded
through the 'D' rings after the seat has been refitted.
Failure to do so will endanger your child.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and
seat base.
F Slide fabric from seat back and base.
G When refitting seat fabric, insert seat back support
tubes into fabric flap.
H When refitting shoulder straps choose the fabric
holes appropriate to the child's size. Twist the
buckles and feed through seat cover, seat back and
then through holes in plastic seat back arms.
J When refitting seat fabric to seat base pass crotch
strap buckle through the hole in the seat fabric and
then hole in seat base.
N OTICE: The seat fabric must wrapped over the top of
the handle tube and fastened by the button hole. After
assembly pull the seat fabric forward and backward to
ensure it will not come off.
10
TO RE-FIT THE SHOPPING BASKET
A place bag on the 'X' frame under seat with
lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above
horizontal tie bar.
11
TO FIT THE RAIN COVER
A Return hood to non-tilted position before fitting
rain cover.
B Ensure visor is folded away beneath the hood.
C place the apron over the hood front.
D Attach two eyelets (one each side) to the
hood clips.
E Attach the two eyelets (one each side) to the
front legs.
12
TO ADJUST HANDLE LENGTHS
A press triggers.
B Slide handles until triggers locate in one of
3 positions. Release triggers to lock.
A
A
C
E
D
G
G
B
A
B
A
B
F
E
H
J
K
C
A
C
D
B
D
E
E
en
F
5

Publicité

Table des Matières
loading

Table des Matières