Maclaren techno xlr buggy Manuel D'instructions page 6

5 TO FOLD THE BUGGY
Fold the hood back, place the seat to an upright position,
remove contents of the shopping bag, then fasten the harness.
A Using foot, lift up on footplate to release primary lock until it
pops up.
B Using your foot, press down on the lever sticking out on the
right hand side of the frame.
C Whilst pressing the lever down with your foot, push the
handles forward and inwards.
D Compress folded buggy and engage storage clip.
Use the handle to carefully carry your buggy.
NOTICE: The buggy should always open and fold easily.
Do not force it. It may be necessary to re-read the instructions.
ASSEMBLY INSTRUCTIONS
6 TO OPERATE THE ADJUSTABLE LEG REST
TO EXTEND THE LEG REST:
Feel through seat corner openings. Locate sliders
and loops and pull forward. Reverse this process
to retract leg rest.
7 TO ADJUST SEAT RECLINE
A T O RECLINE SEAT BACK: position your hand on the seat
recline lever. Gently lift the recline lever with your fingers
whilst taking the weight of the seat back with your hand.
Still maintaining support and holding the lever, gently
recline the seat back in to the desired position. Release seat
recline lever when seat back is in desired position, ensuring
both sides lock at the same time.
B TO RAISE SEAT BACK: From rear of buggy push seat back
to original upright or desired intermediate position.
8 TO ATTACH THE HOOD
A With buggy open clip the hood to the handle
tubes just above the retaining blocks.
B Wrap adjustable straps around handle tubes.
C place rear apron behind seat back.
D Extend hood and press down on side hinges to
lock open.
TO TILT HOOD:
E Fully unzip back panel.
F Tilt hood forward.
G The hood is removed by firmly pressing
down the clip release tabs.
4
A
D
B
C
F
E
B
D
B
A
A
G
C