Starting The Cleaner; Wall Cleaning (Surface Control System ™ ) - Polaris P825 Manuel Du Propriétaire

4. Spread the floating cable over the pool, making
sure there are no kinks or coils in the cable
(see Figure 13).
Figure 13. Spread Floating Cable Over the Pool
4.3

Starting the Cleaner

The first time you use the cleaner, the cleaning surface
setting is Floor and Walls
After the first time, the default is the last setting used.
Default cleaning duration is 1.5 hours for Floor Only
setting, and 2.5 hours for Floor, Walls, Waterline setting.
Select Cleaning Surface:
• Use to change cleaning surface setting.
Begin Cleaning:
• After selecting the cleaning surface,
press to begin operation.
• At the beginning of the cycle, the cleaner
remains in place for a few seconds to initialize
the microcontroller after the pump starts.
NOTE: Periodically the cleaner will pause for up to 20
seconds throughout the cleaning cycle. The cleaner
is calibrating its position in the pool during this
process. This is normal operation and the cleaner will
resume movement immediately after calibration with
no user action required. The pause does not affect
the overall cleaning cycle.
4.4
The cleaner has the ability to clean the pool walls up to
the waterline. How much the cleaner needs to grip to the
wall depends upon the pool surface.
Grip Intensity Indicator:
Surface Control System (SCS) settings are as follows
for different pool surface types:
Check Wall Climbing Setting:
•
.
NOTE: Wall climbing is programmed in a randomized
•
Wall Climbing (Surface Control
System™)
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
Start the cleaner and watch as the cleaner
climbs each wall. If grip setting is correct, the
cleaner will easily climb the wall and clean up
to the waterline. The default setting is
pattern. Cleaner may climb wall and not reach
waterline until third or fourth attempt in order
to thoroughly clean wall surface below the
waterline first.
Adjust the wall climbing setting as necessary
using the following guidelines:
if cleaner is climbing the wall slowly
Increase:
and stays below the waterline.
if cleaner is climbing the wall too
Decrease:
quickly and sucking air at the waterline.
Page 9
1 Pebble Surf
2 Concrete
3 Vinyl / Fiber
4 Tile (SMOOT