Wood's M10G Manuel De L'utilisateur page 12

TROUBLESHOOTING
If a condition listed below occurs, please check the following items before calling customer service.
Problem
The unit doesn't operate
The dehumidifying
function doesn't work
No air is discharged
Operation is noisy
"E1" error code
Technical data Wood's M10G
Max. Working area
Recommended Room Size
Airflow
Capacity (at 30ºC & 80% RH)
Power
Tank Volume
Noice-Level
Working Temperature
Fan Speeds
Dimensions, L x W x H
Weight
Refrigerant
IP Code
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent pos-
sible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustaina-
ble reuse of material resources. To return your device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
English
Possible Cause
Has the power cord been
disconnected?
Is the tank full indication
lamp blinking? (The tank is
full or in a wrong position.)
Is the temperature of the
room above 35° or below
5°?
Is the air filter clogged?
Is the intake duct or
discharge duct obstructed?
Is the air filter clogged?
Is the unit tilted or
unsteady?
Is the air filter clogged?
Defrosted sensor failed.
40 m
2
4-30 m
120 m
10 Litres
280 W
2 Litres
42 dB
+5°C to +35°C
1
276x185x480 mm
9,5 kg
R290
IP21
12
Solution
Plug the power cord into the outlet.
Empty the water in the drainage tank
and then reposition the tank.
The protection device is
activated and the unit
cannot be started.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Remove the obstruction from the di-
scharge duct or intake duct.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Move the unit to a stable, sturdy loca-
tion.
Clean the air filter as
instructed under
"Cleaning the dehumidifier".
Replace defrosted sensor.
2
/h
3