Dyna-Glo SIGNATURE Serie Manuel D'instructions page 13

ASSEMBLY INSTRUCTIONS
Using the Firebox as an Offset Smoker (Optional).
This grill is also compatible as an offset smoker box for
Dyna Glo grill models DGSS675CB-D and DGSS443CB-D.
Optional Step A.
NOTE: The leg assemblies (J) can remain on the
offset smoker box, or removed prior to installing.
When removing the legs, be sure to reinsert the
M6 x 12 bolts into the holes on the bottom section of
the grill/smoker body (K).
To install the offset smoker box, remove the access door
on the side of the primary grill and the adapter plate
(Part M, not shown) on top section of the offset smoker
box (L). Reuse the hardware from the adapter plate and
insert two M6 x 12 bolts with at least 1/4" (6mm) of the
bolt exposed on the left and right side of the opening
on the top section of the smoker box (L). Insert the bolt
heads inside the keyholes on the side of the primary grill.
Do not tighten.
Optional Step B.
Insert the remaining four M6 x 12 bolts from inside the
primary grill body and tighten all bolts - including the side
bolts for the keyholes.
A
B
AA
13
AA
L
K