Publicité
Les langues disponibles
Les langues disponibles
DIAGRAMS
Wiring diagrams, for different optional equipments (see
Fig. I and J);
Key
CH1
Battery charger (optional)
C1
Battery connector
EB1
Electronic board (CFBA430)
EB2
Board LED (CFBALED)
EB3
Drive electronic board
ES1
Brush switch
ES2
Aspirator switch
EV1
Aspirator solenoid valve
F1
Brush fuse (50A)
F2
Aspirator fuse (40A)
F3
Solenoid valve fuse (5A)
F4
Drive fuse (30A)
IS1
Negative insulator
IS2
Positive insulator
K1
Key switch
M1
Brush motor
M2
Aspirator motor
M3
Drive motor
R1
Drive speed governor
SW1
Brush switch
SW2
Aspirator switch
SW3
Drive control micro-switch
SW4
Drive motor micro-switch
Colour codes
BK
Black
BU
Blue
BN
Brown
GN
Green
GY
Grey
OG
Orange
PK
Pink
RD
Red
VT
Violet
WH
White
YE
Yellow
FUSES
Brush safety fuse (50 A): (1, Fig. G)
Aspirator fuse (40 A): (2, Fig. G)
Solenoid valve fuse (5 A): (3, Fig. G)
BA 430S D / BA 510S D versions only:
–
Drive fuse (30 A): (8, Fig. G)
–
Electronic board protection fuse (2A): (9, Fig. G)
08812942(3)2004-05 A
USE AND MAINTENANCE MANUAL
Brush motor overload protection electronic system
This system works when the brush motor is overloaded.
Its operation is signalled by the three warning lights
flashing at the same time (2, 3, 4, Fig. B); after a few
seconds, the brush motor stops.
To restart the motor, eliminate the cause of the overload:
–
The brush is pressed too much on the floor;
–
The brush is blocked by floor roughness or by a
foreign body;
–
The brush rotation is slowed down by dirt, ropes or
rags around its rotation shaft;
–
The friction between brush and floor is excessive
[increase the solution quantity using the appropriate
adjusting lever (7, Fig. B)].
Once the overload cause has been eliminated, reset the
system as follows:
–
(BA 430S / BA 510S versions) stop the machine by
turning switches (5 and 6, Fig. B) to "0" position;
–
(BA 430S / BA 510S versions) stop the machine by
turning the ignition key (9, Fig. B) to "0" position.
After that, the machine can be restarted again, as
described in the related chapter.
Drive motor overload protection electronic system
(BA 430S D/BA 510S D versions only)
This system works when the drive motor is overloaded.
This intervention is signalled by the stopping of the drive
motor.
After a while, the system can be reset by stopping the
machine by turning the ignition key (9, Fig. B) to "0"
position.
After that, the machine can be started again, as described
in the related chapter.
ACCESSORIES/OPTIONS
In addiction to the standard components, the machine can
be equipped with the following accessories/options,
according the machine specific use:
1.
Gel batteries.
2.
Electronic battery charger.
3.
Brush of materials different from the standard ones.
4.
Disks of two different materials.
5.
Squeegee oil-proof blades.
For further information concerning the optional
accessories apply to an authorized retailer.
7
Publicité
Chapitres
Dépannage
