Introduction And Machine Specifi Cations - Clarke American Sanders FA-8 HDTR Mode D'emploi

Introduction & Machine Specifi cations
Drum
Cover
This machine was designed to supply abrasion to coated surfaces before recoating. Abrasion provides anchor sites that promote adhesion of the
new coating to the existing coating. This machine is suitable for use on factory fi nished or site fi nished wood fl oors. This machine is recommended
for beveled, micro beveled, and sculptured factory or site fi nished wood fl oors. It is especially suited for use on uneven or sculpted fl oors where
traditional methods would otherwise damage the fi nish or alter the sculpting.
Model
Abrasive Size
Abrasive Rate
Operating Controls
Motor
Power Cable
Voltage/Frequency
Amperage
Dimensions (in)*
Weight (lbs)*
*Shipping Value
CAUTION!
Your equipment may be inappropriate on some installations. Always consult with the fl ooring manufacturer on the proper installation,
preparation, and fi nishing of their product. Determine suitability of your equipment in preparing the product.
®
American Sanders Operator's Manual (EN) - FA-8 HDTR
Clarke
Dust Pipe
Transport
Handle
Level Ad-
justment
07194A
6" x 7½" (152mm x 190mm)
950 rpm
Lever Operated
5/8 Hp (470W) TEFC 1Ø
50' 14-3 Abrasion Resistant
115 / 60
8
21½x16x35½"
125 lbs (56.8 kg)
ENGLISH
Control Switch
Handle Latch
EN
Operating
Control Lever
Control Link
Locking Collar
- 5 -