Operator Safety Instructions - Clarke American Sanders FA-8 HDTR Mode D'emploi

DANGER!
Severe bodily injury or death can occur to you or other personnel if the DANGER statements found on this machine or in this
Operator's Manual are ignored or are not adhered to. Read and observe all DANGER statements found in this Operator's Manual
and on your machine.
WARNING!
Injury can occur to you or to other personnel if the WARNING statements found on your machine or in this Operator's Manual are
ignored or are not adhered to. Read and observe all WARNING statements found in this Operator's Manual and on your machine.
CAUTION!
Damage can occur to the machine or to other property if the CAUTION statements found on your machine or in this Operator's
Manual are ignored or are not adhered to. Read and observe all CAUTION statements found in this Operator's Manual and on your
machine.
DANGER!
Failure to read the Operator's Manual before operating or servicing this sanding equipment could result in injury to the operator or to
bystanders and could cause damage to the equipment. Read and observe all safety statements found in this manual and on the sanding
equipment. Make sure all labels, decals, warnings, cautions and instructions are fastened to the equipment. Replace any that are damaged
or missing. You must have training in the operation of this equipment before using it. If the operator is unable to read this manual, have it
explained fully before they attempt to use this equipment.
DANGER!
Finishing wood fl oors can create an environment that can be explosive. The following safety procedures must be adhered to:

Cigarette lighters, pilot lights and any other source of ignition can create an explosion when active during a sanding session. All sources of
ignition should be extinguished or removed entirely if possible from the work area.

Work areas that are poorly ventilated can create an explosive environment when certain combustible materials are in the atmosphere, i.e.,
solvents, thinners, alcohol, fuels, certain fi nishes, wood dust and other combustible materials. The machinery can cause fl ammable material
and vapors to burn. Read the manufacturer's label on all chemicals used to determine combustibility. Keep the work area well ventilated.

An accumulation of dust can self-ignite and cause injury or damage and should be disposed of properly. Always empty the dust into a metal
container that is located outside of any building(s).

Do not empty the contents of the dust bag into a fi re.

In the event of a bag fi re, injury can occur to the operator if the operator is tied or strapped to equipment.
®
American Sanders Operator's Manual (EN) - FA-8 HDTR
Clarke

OPERATOR SAFETY INSTRUCTIONS

ENGLISH
EN
- 3 -