Electrical Wiring - Global Industrial HVLS BLDC 293042 Manuel De L'utilisateur

User's Manual
10. Rotate the motor cap (11) to the fan assembly with (H27)
spring washer until tighten.

ELECTRICAL WIRING

1. Open the junction box cover on the hanger rod, and connect
the motor lead wire and 4x16AWG interconnecting cord to the
terminal as shown below, make sure tighten all the terminal
screws.
Junction Box
Motor Lead
Wire
U
V
W
G
HVLS BLDC Fan
H27
11
U U
V
V
W
W
G
G
4x16AWG
Interconnecting
Cord
11.Install the (H25) plastic anchor to the wall at the distance
shown as below. Then install the control box to the plastic anchor
with (H26) ST5x40mm screw.
Warning: Do not install closer than 1 foot (0.3 m) from both sides
of the control box to any adjacent surface/wall.
H26
2.Open the control box wiring cover, and connect the fire alarm
wire, 4x16AWG interconnecting cord and power-supply
conductor as shown below.
OVERLOAD
OFF
PROTECTION
REV
FWD
PRESS TO
ON
RESET SPEED
Fire Alarm Switch
- +
FIRE
- +
Lead Wire of
Power-Supply
Fire Alarm
Conductor
Note:
1. The factory default setting of the fire alarm swtich is OFF.
After the fire alarm connection is completed, press the fire alarm
switch ON. Otherwise, the fire alarm can not work.
2. If you do not want to connect the fire alarm, make sure the fire
alarm switch is OFF. Otherwise, the LED will show EF1 NG, and
the fan can not run.
9
H25
OVERLOAD
PROTECTION
PRESS TO
RESET
SPEED
ON
OFF
- +
G L1L2
POWER
FIRE
G
- + L1L2
FIRE
ALARM
ON
OFF
G L1L2 G U V W
POWER MOTOR
G
L1L2 G U V W
4x16AWG
Interconnecting Cord
OFF
REV
FWD
ON
G U V W
MOTOR
G U V W