Global Industrial HVLS BLDC 293042 Manuel De L'utilisateur page 6

1. Loosen the 12 screws and washers which on the motor hanger
assembly.
2. Install the fan blade holder to the motor assembly with screws
and washers as below picture, make sure tighten all the screws
and washers.
H10
H19
H15
5
H10
H19
H15
Screws and washers must be installed in pairs.
(H10)M8x70mm Screw must be installed with (H19) 8mm spring
washer and (H15) 8mm flat washer.They should be tighten with
36N.M torgue.
(H6)M12x50mm Screw must be installed with (H18) 12mm
spring washer and (H14) 12mm flat washer.They should be
tighten with 135N.M torgue.
HVLS BLDC Fan
3. Install the I-Beam mounting bracket to the I-Beam with the I-
Beam mounting spacer 1&2 to the (H20) 14mm nuts, (H21) 14mm
Self-tapping Nut, (H17)14mm Spring Washer, (H13) 14mm flat
washer and (H5) M14x50mm screw, make sure all the screws and
washers are tighten with 135N.M torgue.
H17
H13
H13
H6
4. Install the hanger rod to the mounting bracket with (H7)
H18
M14x110mm screws, (H13)14mm flat washers and (H21)14mm
self-tapping nuts.
H14
H21
H6
H18
H14
6
H20
H5
H13
4
User's Manual
H21
3
2
1
H7
H13