Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Read instructions carefully before assembling or installing
your fan. It is important that you observe all safety information
to help prevent personal injury and/or property damage.
1.Installation work and electrical wiring must be performed in
accordance with the requirement of NEC and CEC by
authorized personal only.
2.All wiring and installation procedures must satisfy National
Electrical Codes (ANSI/ NFPA 70) and Local Codes.
3.Use this fan only in the manner intended by the manufacturer.
This fan is intended for permanent installation and to be used
for circulation only.
4.The secondary support cable included with the fan must be
properly connected.
5.To Reduce The Risk Of Personal Injury, Do Not Bend The Blade
Brackets When Installing The Brackets, Balancing The Blades,
Or Cleaning The Fan. Do Not Insert Foreign Objects In Between
Rotating Fan Blades..
6.Before servicing or cleaning unit, switch power off at service
panel and lock service panel disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
warning device, such as a tag, to the service panel.
7.Be careful of the fan and blades when cleaning, painting, or
working near the fan. Always turn off the power to the ceiling
fan before servicing.
8.Ceiling fans without guards are to be installed at least 3.05
Meters (10 Feet) above the floor with adequate clearance
between blades and adjacent walls, furnishings, etc.
9.When mounted in cathedral ceiling, blade tips should be at least
1 foot from the angled roof line or air turbulence may cause the
fan to sway.
10.The supporting beam must be capable of holding at least
600 KGS.
11.All set screws must be checked, and retightened where
necessary, before installation.
Model
Size(ft)
Voltage(V)
Frequency(Hz)
Wattage(W)
RPM
AMPS(A)
Hanger Rod Dimensiond(inch)
Blades
Net Weight(KG)
Certification
HVLS BLDC Fan
GENERAL SAFETY INSTRUCTIONS
SPECIFICATION
293042
12
240
60
680
20-88
4.8
20
6
75
UL,cUL
Disconnect the fan from the power supply
before any servicing.
To Reduce The Risk Of Personal Injury, Do
Not Bend The Blade Brackets When Installing
The Brackets, Balancing The Blades, Or
Cleaning The Fan.
Do not insert foreign objects in between
rotating fan blades.
TO REDUCE THE RISK OF SHOCK, THIS FAN
MUST BE INSTALLED WITH A GENERAL USE
ISOLATING WALL CONTROL/SWITCH.
To Reduce The Risk Of Fire Or Electric Shock,
Do Not Use This Fan With Other Types Of
Solid-State Speed Control Devices.
For commercial and industrial use only !
293043
293044
14
16
240
240
60
60
600
820
20-65
20-78
4.3
5.7
20
60
6
6
78
115
UL,cUL
UL,cUL
2
User's Manual
293045
293046
18
20
240
240
60
60
930
810
20-65
20-55
6.3
5.6
60
60
6
6
118
123
UL,cUL
UL,cUL
Publicité
Table des Matières
