Connections - Kenwood SW-45HT Mode D'emploi

Connections

If your amplifier or receiver outputs only the L/R
separated, line-level signals, it is necessary to use
an adapter for synthesizing the L and R signals (not
provided) in order to connect the Subwoofer to
such an amplifier or receiver.
• In case an associated system component is
connected, also read the instruction manual of the
component.
• Be sure to insert all connection cords securely. If
connections are imperfect, the sound may not be
produced or noise may interfere.
¤ CONNECTION PRECAUTIONS
Do not connect the power cord plug to the power
outlet until all other connections are complete.
Before unplugging a cord or cable from the unit,
be sure to always set the POWER switch to OFF and
unplug the power plug from the power outlet.
ON
MINI MAX
VOLUME
LINE IN
ON OFF
AUTO STANDBY
LINE IN
OFF
POWER
AC IN
¤ CAUTION
Simply setting the POWER switch to OFF does
not shut down the power supplied to the unit
completely. To isolate this unit completely from the
power supply, it is necessary to unplug the power
cord from the power outlet.
To shut down the power supply to the unit
immediately in case of an emergency, connect the
power plug to an easily accessible power outlet.
The mains plug is used as the disconnect device. It
should remain readily operable and should not be
obstructed during intended use.
Amplifier or Audio Video control center
Pin-plug cord
To AC wall outlet
• Insert the plug firmly all the way into the AC wall
outlet.
5
English