Blade Maintenance; Replace The Blade; Store The Machine; Troubleshooting - GreenWorks SH24B00 Manuel D'opérateur

EN
Do not touch the moving blades.
To ensure long and reliable service, carry out the following
maintenance regularly.
• Regularly check for obvious defects such as loose fixings,
and worn or damaged components.
• Ensure that the guard and protective devices are
undamaged and properly mounted. Before using, carry
out any necessary maintenance or repairs.
• If the garden product should happen to fail, repairs should
always be carried out by an authorized customer service
agent for garden products.
9.1

BLADE MAINTENANCE

• Always clean and lubricate the blades after use.
• During longer cutting jobs, we recommend periodically
lubricating the cutting blade.
• Visually check the condition of the blades cutting edges.
• Ensure that the cutting blade is stored with the blade
guard supplied when not in use.
9.2

REPLACE THE BLADE

3
7
Always wear protective gloves when using, adjusting or
cleaning the garden product.
Do not change the blade without blade covers.
1. Press the blade assembly release button.
2. Lift the blade assembly away from the housing.
9.3

STORE THE MACHINE

Switch off before adjusting or cleaning. The blades continue
to move for a few seconds after the garden product is
switched off.
WARNING
NOTE
WARNING
WARNING
WARNING
English
Do not touch the moving blades.
Always wear protective gloves when using, adjusting or
cleaning the garden product.
• Clean the exterior of the device thoroughly using a soft
brush and cloth. Do not use water, solvents or polishes.
Remove all debris.
• Carry the device by the handle with the cutter blade
stopped. When transporting or storing the hedge trimmer
blade always fit the cutting device cover.
• Store the device in a secure, dry place out of the reach of
children. Do not place other objects on top of the device.
10

TROUBLESHOOTING

Problem
The machine does
not start.
Motor runs, but
cutting blades do
not move.
Motor hums,
blades do not
move.
11

TECHNICAL DATA

Voltage
No load speed
Weight (without battery
pack)
Vibration
Battery model
Charger model
Grass shear mode:
Blade length
Cutting capacity
10
WARNING
WARNING
Possible cause Solution
The battery ca- Charge the battery
pacity is low. pack according to
the instructions in-
cluded with your
model.
The battery pack is Charge the battery
too cold. pack.
The battery pack is Make sure the bat-
not attached to the tery pack is instal-
engine. led correctly.
Hedger damaged. Call for technical
Do not use garden service.
shear.
Debris may be Switch off, clear
jamming the debris blockage
blades. from blades.
24 V
1400 / min
1.1 kg (2.43 lbs)
2
< 2.5 m/s , K = 1.5 m/s
BAG711 and other BAG ser-
ies
CAG801 and other CAG ser-
ies
150 mm (5.91 in.)
20 mm (0.79 in.)
2