Lavorwash PREDATOR DGT WPS Instructions De Montage page 17

WPS Washing Program System
Buttons:
① Main switch 0/I
② Soft wash (SOFT)
③ Medium wash (MEDIUM).
④ Hard wash (HARD).
Lights:
⑤ Child safety (orange).
⑥ Green LED.
⑦ Yellow LED.
⑧ Red LED.
⑨ Maintenance.
⑩ Power indicators ( SOFT,
⑪ Overheating.
Start-up
①
- Insert the plug in the power outlet, the 0/I button
① becomes blue.
- Press the gun lever until water comes out.
- Press the blue 0/I button ① which becomes red.
Washing programs
② ③ ④
- Each time the 0/I button ①is turned on, the
machine starts with the SOFT wash program ②.
- To change the program, press MEDIUM ③ or
HARD ④.
- See the paragraph "WPS Washing Program System".
Green rectangular light
⑥
- The machine is on and working.
Yellow rectangular light
⑦
- The machine is in stand-by. To reactivate it, simply
press the gun lever.
Fixed red rectangular light
⑧
- Safety function. The electrical power supply is
deactivated because the machine has not been
used for more than 15 minutes (prolonged stand-
by). To turn the motor back on,
press the 0/I button ① twice.
MEDIUM, HARD).
Flashing red rectangular light
⑧
- Safety function. The electrical power supply
to the motor is deactivated because of leaks in
the hydraulic circuit. To turn the motor back on,
press the 0/I button ① twice. See the paragraph
"Remedies in case of malfunction".
Child safety
⑤
- Press SOFT ② and HARD ④ at the same time
for ③ seconds, until the Child safety symbol ⑤
flashes.
- The water jet does not come out even if the gun
lever is pressed; the buttons are locked too.
- To unlock the machine, repeat the operation.
Ordinary maintenance
⑨
The light ⑨ turns on after at least 10 hours
of operation. See the paragraph "Care and
Maintenance."
- Clean the filter in the water connection.
- Cleaning of nozzle. Use a small paper clip to free
foreign material clogging
or restricting spray tip.
- O-Ring Maintenance. The use of lubricant
(petroleum or synthetic grease) helps seat o-rings
providing an improved seal. Apply lubricant to
o-rings prior to assembling high pressure hose
(pump end) , high pressure hose (gun end) ,
garden hose to the pump , and plastic wand (gun
end). Purchase an O-Ring Maintenance Kit by
contacting
- Remove all debris, especially from the ventilation
slots.
- Check high-pressure hose.
- Check the power cable and plug.
- To turn the light off, press SOFT ② and MEDIUM
③ at the same time for 5 seconds.
Overheating
⑪
- The light ⑪ turns on when the temperature inside
the machine exceeds the preset threshold. It does
NOT indicate a technical problem.
- Move the machine to a ventilated place and/or let
it cool down.
- Turn off the machine by pressing the 0/I button ①
and disconnect the plug from the power outlet.
17