Explanation Of The Application Range - Emerson Klauke AHP 700-L Mode D'emploi

Instruction Manual Battery-hydraulic Pump
AHP 700-L
Once the three step safety foot switch has been stepped down, it can only be reactivated by pushing the reset button
of the foot switch. This reset button is located on the top of the foot switch.
After the two hand safety control ZST4 (Picture 25.3) had been activated it must be reactivated by pulling the knob.
Attention
After having terminated the working cycle and prior to changing the dies remove battery to avoid un-
intended use. Avoid unintended starts. Make sure the switch is in the off position before plugging in.
For transport turn the program selection switch (pic. 1.8) to position 7 to avoid unintended starts.

4.2 Explanation of the application range

The battery hydraulic pump can be operated with all of the cutting-/crimping- and punching heads in our catalogue.
Attention
Do not crimp/cut or punch on live cables or conductors.
Before starting to work make sure there are no live lines in the working area.
The tool is not designed for continued operations. After a sequence of approximately 100 completed cycles you have
to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly infl ammable or explosi-
ve liquids and materials
Attention
Electric-hydraulic tools should not be operated in pouring rain or under water.
The tool can be operated in a temperature range of -12°C bis +40°C inside as well as outside.
Abb. ähnlich / pic. similar
WORK
HE.14138_H © 09/2011
SERVICE DON´T DO
General
safety rules
GB
8