Westfalia 82 50 10 Mode D'emploi Originale page 17

Cleaning and Maintenance
Before cleaning or maintaining, first disconnect the air hopper spray gun

from the air supply.
After use thoroughly rinse the spray gun and the hopper. When using water-

soluble coating material, simply clean all parts of the hopper spray gun
thoroughly with water.
Should it be necessary to disassemble the hopper spray for thoroughly

cleaning, observe the correct order of the components when assembling the
spray gun. Always be careful when disassembling and assembling the spray
gun.
Lubricate all moving parts of the hopper spray with suitable non-silicone

grease. All parts such as nozzles, seals, adjusters, etc. are wear parts and
must be exchanged with original spare parts in frequent use.
Caution: Avoid screwing the material fluid control knob (10) completely out
of the spray gun, otherwise the seal may be damaged. The material quantity
limiter may only be unscrewed until the thread becomes visible.
Use a moist cloth to clean the housing of the spray gun.

Do not allow liquids to enter the tool and never immerse it into liquids.

Water in the compressed air inlet can damage the machine. Therefore it is
recommended to drain the air line and the compressor in regular intervals!
Also clean the air filters in regular intervals.
Storing
Store the air hopper spray gun indoors in a dry place that is protected from

dust, dirt and extreme temperatures.
Store the spray gun out of reach of children.

Technical Data
Air Consumption:
Operating Pressure Range:
Maximum Air Pressure:
Air Inlet:
Hopper Capacity:
Weight incl. Hopper:
Nozzle Sizes:
140 – 220 l/min
3 – 5 bar
6.2 bar
G¼"
Approx. 5 l
Approx. 788 g
Ø 4, 6, 8 mm
17