Connect Wiring - NuTone ALLURE WS1 Serie Mode D'emploi

Masquer les pouces Voir aussi pour ALLURE WS1 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
10 Remove appropriate Duct Knockout(s) from top or back of
hood.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
11 3¼" x 10" Ducted Discharge Only: Attach Damper/Duct
Connector over knockout opening. Make sure damper Pivot
is nearest to Top/Back Edge of hood. Remove Tape from
damper flap.
NOTE
Damper/Duct Connector can be installed up to 1-inch
on either side of hood center to accomodate off-center
ductwork. In extreme off-center installations, one end
of the duct connector may need to be trimmed to clear
the electrical cable clamp.
All manuals and user guides at all-guides.com
(Continued)
TOP/BACK
TAPE
EDGE
DAMPER/DUCT
CONNECTOR
(Vertical discharge
position shown)

CONNECT WIRING

WARNING: To reduce the risk of electric shock,
make sure power is switched off at the service
panel. Lock or tag service panel to prevent power
from being switched on accidentally.
1
Connect House Wiring (120 VAC) to hood. Use a piece of
Cardboard to protect the cooktop, if necessary.
2
Connect house BLACK to hood BLACK wire, house WHITE
to hood WHITE wire, and house ground under GREEN
Ground Screw. Securely tighten cable clamp onto house
wiring.
3
Replace wiring cover.
ALLURE
®
WS1 SERIES
RANGE HOOD
Page 4
HOUSE
WIRING
(120 VAC)
CARDBOARD
(Use to protect
cooktop)
GREEN
GROUND
SCREW

Publicité

Table des Matières
loading

Table des Matières