Cleaning And Care; Disposal Information - Melitta epour Mode D'emploi

• A subsequent, brief press (<1 sec.) of the BREW
button starts the descaling process.
• Once about half of the liquid has run through the
appliance, stop the process by pressing the BREW
button again briefly (<1 sec.).
• Wait for 10 minutes to ensure that the remaining
descaling fluid removes as much limescale from the
appliance as possible.
• Next reactivate the appliance by pressing the BREW
button longer (>1 sec.) and then briefly (<1 sec.). Allow
the remaining fluid to run through the appliance.
• If you hear a signal sound, switch the appliance off by
pressing the BREW button longer (>1 sec.).
• Empty the jug.
5.2 Rinsing process after descaling
• The appliance must be rinsed after descaling to remove
any remaining descaling agent.
• First rinse out the water tank under running water.
Then fill the water tank up to the 8-cup mark and put
it back into the appliance.
• Activate the appliance, start it, as in a normal brewing
process, and allow all of the water to flow through the
appliance.
• If you hear a signal sound, switch the appliance off by
pressing the BREW button longer (>1 sec.).
• If the appliance was completely descaled during the
descaling process, the CALC lamp will no longer be
illuminated during the rinsing process. If this is still
the case, the limescale in the appliance was so far
advanced that one descaling process was not sufficient
to completely descale the heater. In this case, repeat
the descaling and rinsing process one more time.
• Empty the glass jug.
• Then rinse out the glass jug with water.

6. Cleaning and care

• Switch off the appliance before cleaning and disconnect
the mains plug.
• Allow the appliance to cool down completely before
cleaning it.
• Clean the parts that come into contact with coffee
(jug, filter holder etc.) after each use.
• You can clean the housing with a soft, moist cloth.
• The glass jug with lid, the filter holder and the water
tank lid are dishwasher-safe.
• When cold, the keep-warm plate can be cleaned with
a soft, moist cloth.
• Do not use aggressive or abrasive cleaning agents.
7. Switching off the signal sounds
All signal sounds can be deactivated if necessary.
The appliance needs to have been switched off to do
this. Pressing the BREW and CONTROL buttons at
the same time longer (>1 sec.) deactivates the signal
sounds. Proceed in the same way to switch them on
again. You will hear a brief signal sound upon activation
and upon deactivation

8. Disposal information

• Appliances marked with this symbol
to the European Directive for WEEE (Waste Electrical
and Electronic Equipment).
• Electrical appliances do not belong in domestic waste.
• Dispose of the appliance in an environmentally friendly
way via suitable collection systems.
• The packaging materials are raw materials and recyclable.
Please return them to the raw materials cycle.
are subject
GB
11