Table des Matières
Publicité
Features of Your Auto-Off Iron
1. SPRAY MIST
Release
®
2. Covered Water Fill Hole
3. Steam Dial
4. SHOT OF STEAM
Button
®
5. SPRAY MIST
Button
®
6. 360° Tangle-Free Swivel Cord
7. Power Indicator Light
8. Maximum Fill Line
9. Fabric Select Dial
10. Self Clean Button
11. See-Through Water Reservoir
12. Soleplate
t
f
W
R
o
Ill the
ateR
eseRVoIR (use tap water)
1. Make sure the iron is unplugged. Set the Steam Dial to
Select Dial to MIN.
2. Lift the Water Fill Hole Cover.
3. Fill an easy-pour measuring cup with tap water and pour water into iron water
reservoir. Do not fill water reservoir beyond maximum fill level.
WARNING:
To prevent the risk of burns, be careful when filling a hot iron with
water. Hot metal parts, hot water and steam can cause injuries.
d
I
Ry
RonIng
5
4
3
2
1
12
Visit www.sunbeam.ca for an Ironing Guide and Ironing Tips
Voyez le guide et les conseils de repassage au www.sunbeam.ca
(Dry) and the Fabric
Caractéristiques du fer
6
8
9
10
11
s
y
I
toRIng
ouR
Ron
1. Turn off iron following instructions above. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir after
each use for a longer iron life. To do so, unplug the iron, turn the iron upside
down, open the fill hole cover, and allow water to flow from the fill hole. Shake
the iron gently to remove trapped water drops.
3. Loosely loop the power cord around the heel rest and store the iron on its heel rest.
IMPORTANT:
Wrapping the cord around the iron too tightly can damage
the cord.
arrêt automatique
à
1. Orifice d'atomisation SPRAY MIST
2. Orifice de remplissage à volet
3. Variateur de vapeur à cadran
4. Bouton de SHOT OF STEAM
5. Bouton d'atomisation SPRAY MIST
6. Cordon articulé 360°, non emmêlant
7
7. V oyant d'alimentation
8. Repère maximum de remplissage
9. Cadran de sélection des textiles
10. Bouton d'autonettoyage
11. Réservoir à eau translucide
12. Semelle
MD
MD
MD
Publicité
Table des Matières
