Maintenance - Kasanova LAT000001NOC Manuel D'instruction

PRESSURE COOKER
20
The safety valve
releases steam.
The steam is relea-
sed from the around
area.

6. MAINTENANCE

1.) Cooker body
Use detergent to clean dirty areas.
Dry the pressure cooker.
Don't touch the cooker body directly with metal tools.
Don't let the cooker touch the iron-related metal.
2.) Gasket
Use detergent to remove impurities on the lid.
Dry up the gasket totally.
Install the gasket in the proper position.
Use detergent or water to wash the gasket after used. After drying up the gasket, put it in
the proper position on the lid and keep it flat. Replace the original gasket after long time
used.
3.) Regulator valve, vent-pipe, safety valve
If the pressure regulator valve, vent-pipe and safety valve are obstructed with food residues
and other things, use small stick to clean and make sure the water passes fluently. Please
check the screw cap is well fixed. If it is flexible, reassemble again.
Every time after using, clean the regulator valve directly under the jet of water.
4.) Remove the burn marks
Use soft wood products to remove the marks.
Leave the pressure cooker in the sun to let it dry, then plunge it in oil. Leave it to soak in hot
water for a while and then remove the burn marks, without using sharp tools.
5.) Maintenance
Clean the body and the lid. Remove the gasket for cleaning.
Use a small stick to remove the food residues from the regulator valve, vent-pipe and the
safety valve.
Please put it in dry places.
Please keep the cooker body and lid separately.
-- Special notice
1.The ventilator holes are
blocked.
2.There is much food inside
blocking the valve.
3. The flame is too strong.
1.The regulator valve and the
safety valve do not work.
2.The gasket is not correctly
positioned.
3.The gasket is damaged.
4.The gasket is not clean.
5.The lid is not fully closed.
1. Get rid of the matter.
2. Remove the food residue.
3. Use middle fire to heat,
adjust the
regulator valve and choose
the
suitable pressure level.
1. Remove the food residue
with a
needle or something sharp.
2. Laid the gasket in correct
position.
3. Replace the gasket.
4. Clean the gasket.
5. Lock the lid properly