Symbols Used - Renfert EASY view+ 3D Guide De Démarrage Rapide

Introduction
This Quick Start Guide contains instructions on the operation of the product and relevant
safety information.
For detailed information about the device, see the instructions for use which you can down-
load from our website at www.renfert.com/p918.
Enter the following item number: 2400 3000.
After initial start-up, check whether a newer software version is available for the EASY view+.
The version number of the software installed on your EASY view+ is displayed on the bottom right of the
screen after switching on (see Chap. 5.1).
Software updates are available on our website at www.renfert.com/p918.
Enter the following item number: 2400 3000.

Symbols used

This manual contains symbols also found on the appliance itself with the following meaning:
Danger
Immediate risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of injury due to electrical current.
Caution
Risk of damage to the unit if the instruction is not followed.
Notice
A general notice that improves and eases use.
The appliance complies with applicable EU directives.
Within the EU, this device is subject to the provisions of the directive 2002/96/EC
(WEEE directive).
Other symbols are explained when displayed.
Safety
Correct use of the unit
The system is used for digital stereo-magnification in 2D and 3D in real-time and for documentation.
Unapproved Use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this product. If other
spare parts or accessories are used, this could have a detrimental effect on the safety of the device, increase the risk
of serious injury and lead to damage to the environment or the device itself.
Hazards and Warnings
General information
► Granted protection is not given any longer in case the unit is not operated according to the instruction man-
ual on hand.
► The unit should only be operated using a mains cable with a country-specific plug system. Any modification
required should only be carried out by an electrician.
► The unit should only be operated if the data on the rating plate corresponds with the data of regional mains
voltage.
► The unit should only be plugged into earthed sockets.
► The mains socket should be easily accessible.
► Disconnect the unit from the mains before working on electrical parts.
► Regularly check connecting cables (such as power cables), hoses and housing (for example, the control
panel) for damage (for example, kinks, tears, porosity) or deterioration due to aging.
Do not operate units with damaged connection cables, hoses or housing parts or other defects!
► Damaged equipment must be taken out of service immediately. Disconnect from mains and secure against
being switched on again. Send the device in for repair!
► Operate the equipment only under supervision.
► Observe national accident prevention regulations!
► It is the responsibility of the operator that national regulations during operation and regarding a repeated
safety inspection of electrical equipment are complied with.
For Germany these are the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with
VDE 0701-0702 (Association for Electrical, Electronic and Information Technology).
► Information on REACH and SVHC is available on our website www.renfert.com in the Support area.
Specific information
► Do not look into the lighting.
► As with all optical magnification systems, working with the system for long periods can lead to symptoms of
fatigue. Take breaks regularly.
► The 3D goggles do not replace protective eye equipment in any way.
- 1 -
en