Connecting The Hardware - Zyxel ZyWALL USG 100 Serie Mode D'emploi

3 Connecting the Hardware

1 It is recommended that you configure the ZyWALL before using it to protect your network. Use an Ethernet
cable to connect a computer to port P4.
2 Use another Ethernet cable(s) to connect port 2 and/or port 3 to an Ethernet jack with Internet access.
3 Use the included power adaptor to connect the power socket (on the rear panel) to a power outlet.
4 Look at the front panel. The PWR light turns on. The SYS light blinks during system testing and
initialization and then stays on when the system is ready.
4 Web Login
1 Launch your web browser and go to http://192.168.1.1 (the
ZyWALL automatically redirects you to https://192.168.1.1).
ENGLISH
3