Seal & Peel Tonneau Only - LUND 900122 Instructions D'installation

Installation Steps
Seal & Peel Tonneau Only
Unroll cover and follow directions below to fasten
cover to tonneau rails.
B
8A
A
Place tan tip of the cover retainer under the
A
upper lip of the tonneau rail.
Rotate the retainer downward.
The tension of the cover will fully engage
the cover retainer into the tonneau rail.
A
NOTE: It is recommended to complete
this step on all three sides before pro-
ceeding to the next step.
B
A Using palm pressure, glide hand down the
length of each tonneau rail to lock the
cover retainer into the tonneau rail.
To disengage cover, pull upward and out,
starting at a corner end.
B
PAGE 6 of 8
1703142E
Rev.2
A