VALBERG 973783 Consignes D'utilisation page 25

B
Product usage
Screen-off function
Notes: By default, the panel display automatically turns off after 60 seconds of
no operation.
Button Usage
combination
Screen-off function
• The Screen-off function is activated by default.
• Press and hold
the Screen-off function.
+
• When in Screen-off mode, press any button (except
control panel display. If there is no operation for 60 seconds, the display
returns to Screen-off mode.
Tip-over sensor
The heater has a safety sensor that will enter Standby mode automatically when it tips over.
If the heater tips over, place the heater in upright position and press
Control panel display error code reference
Panel display Description of abnormal state
E1 Displayed when the temperature sensor is in open circuit.
E2 Displayed when the temperature sensor is in short circuit.
High temperature alarm fault code displayed when the ambient
FF
temperature exceeds 50°C.
Remote control unit
The remote control unit can be used within 5 metres (with no obstructions) of the heater.
Aim the remote control unit at the control panel of the main unit.
Button icon Button name
Power button
Oscillation button
Mode button
and together for 3 seconds to activate or deactivate
Usage
• Press to power on or enter Standby mode.
• Press to toggle between On mode and Standby
mode.
• When in On mode, press to start or stop oscillating.
• When in On mode, press to toggle between 01 (low
heating) and 02 (high heating). With high heating
mode, the heater reaches your set temperature
faster than with low heating mode.
25 EN
) to wake up the
to turn it back on.