Troubleshooting - turbionaire REVIGO10 Manuel D'instructions

Switch off the unit and
remove the two air
filters.
CLEANING UP OF REFRIGERANT
General Measures:
- Gas/vapor heavier than air. May accumulate in confined spaces, particularly at or below
ground level.
- Eliminate every possible source of ignition.
- Use appropriate personal protection equipment (PPE).
- Evacuate unnecessary personnel, isolate, and ventilate area.
- Do not get in eyes, on skin, or on clothing. Do not breathe vapors or gas.
- Prevent entry to sewers and public waters.
- Stop the source of the release, if safe to do so. Consider the use of water spray to disperse
vapors.
- Isolate the area until gas has dispersed. Ventilate and gas test area before entering.
Contact competent authorities after a spill.

7. TROUBLESHOOTING

Symptom
The unit
Check the power connection in
is not securely.
operating. Check if the water level indicator
lights up?
Check the room temperature.
The unit
Check the air filter for dirt.
works
Check if the air duct is blocked.
with
Check if the room door or window
reduced
is open.
capacity.
Check if the desired operating
mode is selected and the
temperature is properly set.
The exhaust hose is detached.
Rinse the air filter
under running water.
Inspection
WARNING!
Do not touch the
evaporator surface
with bare-hand, or
could cause injury of
your fingers.
Solution
 Insert the power cord securely into
the wall Outlet
 Empty the drain pan by remove the
rubber plug.
 The range of operating
temperature is 5-35℃.
Clean the air filter as necessary.
To clear the obstacle.
Keep the door and windows closed.
Set the mode and temperature at
proper set-point according the
manual.
Make sure the exhaust hose is
securely attached.
14