General Assembly Requirements; Assembly Equipment; Tools Required For Assembly; Assembly Instructions - SKYLOTEC MOBILFIX AP-018 Instructions De Montage Et D'emploi

4.

GENERAL ASSEMBLY REQUIREMENTS

All individual parts must be cleaned of dirt prior to assembly. The use of aggressive materials and chemicals on
the system, as well as contact with plaster, cement or similar agents, must be avoided. Immediately remove any
injection mortar residue or other impurities, so that correct functioning of the product is not adversely affected.
Assemble the Mobilfix terminal in strict compliance with SKYLOTEC design documents. Deviations are not
permitted. Only original SKYLOTEC parts should be assembled and used. The use of components or elements of
other manufacturers or suppliers may endanger the life of the user! Components must be handled with care and
must not be thrown!
The following securing devices are prescribed if installation involves free-standing structures:
Safety harnesses in accordance with DIN 7478 or EN 361, separate rope lanyards with shock absorbers pursuant
to EN 345/355
4.1

Assembly equipment

Sufficient quantities of injection mortar (Würth WIT-PE 500) and a static mixer (Würth 0903 488 121)
should be carried along for installation purposes. These parts are not included in the scope of delivery.
Ask your local dealer for this parts. An M20 nut of at least A2 quality is needed for installation on steel
structures.
4.2

Tools required for assembly

Impact drill for concrete substructures
Concrete drill bit: Ø 24mm
Blow pump to clean drilled hole (Würth art. no. 0903 990 001)
Steel brush to clean drilled hole (Würth art. no. 0905 490 008)
Cartridge applicator gun (Würth art. no. 0891 009 for 385ml cartridges)
WIT-PE 500 injection mortar cartridges (Würth art. no. 0903 480 001 385ml or Skylotec art. no
AP-018-KLEBER-385)
Static mixer (Würth art. no. 0903 488 101)
Hand drill for steel substructures
Metal drill bit: Ø 22
M20 tap and die set (incl. metal drill)
Screw locking fluid (extra strong)
Proof load tool (extra eyelet just for testing)
5.

Assembly instructions

Mobilfix on concrete substructure (
5.1.1
5.1.2 Mobilfix when installed with Würth injection
Mobilfix on steel structures (hexagon nut)
5.1.3
MAT-MA-0007 MOBILFIX
injection bonding method)
mortar WIT-
PE 500
Stand: 08/11/2016 Seite 4 von 16