Technical Data - Beninca THINK P 480V Mode D'emploi

TECHNICAL DATA

Power supply
Output supply
Power maximum motor
Output supply accessories
Protection level
Operating temp.
Radio receiver
Terminal No. Function
1-2-3 Motor
4-5 Flashing light
5-6 AUX
9-10 Courtesy light
11-12 24Vac
13-14 SCA/PhotoTest
15 COM
16 SWO
17 SWC
18 PHOT 1
19 PHOT 2
20 PHOT 3
21 PHOT 4
22 STOP
23 OPEN
24 CLOSE
25 PED
26 Step-by-step
27 COM
28-29 DAS
30-31 Aerial
32-33 2 radio channel
nd
230 Vac 50/60 Hz
480Vac three-phase
2200 W
24Vdc 500mA max.
IP54
-20°C / +50°C
Removable connector for radio receiver
THINK Control Unit
INPUT/OUTPUT FUNCTIONS
THINK Control Unit
Description
Connection, 480Vac motor - three-phase:
1-U/2-V/3-W
Check that the voltage selection jumper on terminals 36-37-38 is correctly positioned.
Connection of flashing light, 230Vac 40W max.
Connect a negative electric brake to this output.
WARNING: Output, 230Vac 0,5A max.
Free N.O. contact (2A 150W) to control the Courtesy light which is timed according to the
TLS parameter.
Output, accessory power supply 24Vac/0,5A max
Output, 24Vac/0,5A max. This can be preset as open gate indicator light or as checked
devices power supply (PhotoTest) through the TSTP logic.
In the event of presetting as PhotoTest, please refer to the diagram "Connection of checked
safety devices"
Common for limit switches and photocells
Input, OPEN limit switch (N.C. contact)
Input, CLOSE limit switch (N.C. contact)
Input, Photocell 1 (N.C. contact). It can be disabled in the opening phase, see PHO1 logic.
Input, Photocell 2 (N.C. contact). It can be disabled in the opening phase, see PHO2 logic.
Input, Photocell 3 (N.C. contact). It can be disabled in the opening phase, see PHO3 logic.
Input, Photocell 4 (N.C. contact). It can be disabled in the opening phase, see PHO4 logic.
Input, STOP push-button (N.C. contact)
Input, OPEN push-button (N.O. contact).
Input, CLOSE push-button (N.O. contact)
Input, pedestrian push-button (N.O. contact)
Input, step-by-step (N.O. contact)
Common for all other control inputs.
Input, safety edge contact.
Resistive edge: closed " DAS" jumper.
Mechanical edge: open "DAS" jumper.
When the safety edge is activated, the gate movement stops. The gate movement is re-
versed for approximately 3 sec if the INVA logic is ON. If no safety edge is used: "DAS"
Jumper open, jumper between terminals 28-29.
Connection of the antenna to the receiver extractable board (30-signal/31-screen).
Output, 2 radio channel of the two-channel extractable receiver.
nd
11