Saeco AROMA COMPACT SE Mode D'emploi Et D'entretien page 32

English
6.5 Replacement of the thermostat to
reduce the coffee dispensing group
temperature.
Remove cup heating bowl (1). Disconnect group thermostat
(2) (Code WGADM1561 – T 103°C) and replace it with
the lower temperature thermostat (Code WGADM2067
- T 93°C), included in the machine equipment.
6.6 Spouts included in the
supply.
No. 4 spouts are supplied with the machi-
ne to dispense one or two coffees.
The figure (beside) shows the different
distances from the cup-holding tray (H),
depending on the different types of spouts
fitted on the filter holder.
7- FUNCTION / USE AND
PROGRAMMING
INTRODUCTION
The programming software permits the checking of the
following operations:
- handling of 1 - 2 coffee units
- control of four different coffee doses for each unit
- simultaneous function of both coffee and tea units
- volumetric check on coffee measures
- simulated measure programming
- filling level check and control
- system supervision through alarms
- continuos, delivery time-out and further functions
- serial connection with accounting devices
32
fig. 9
fig. 10
Keyboard symbols:
T1 – single espresso coffee
T2 – double espresso coffee
T3 – single long coffee
T4 – double long coffee
T5 – Programming/continuos