Preparation; Oven Door Removal - Wolf E Serie Guide D'installation

INSTALLATION

Preparation

Before moving the oven, protect any finished flooring and
secure oven door closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.

OVEN DOOR REMOVAL

To remove, open oven door completely. Rotate both hinge
latches forward to the open position. Close door to the
"at-rest" position, then lift up and out. Refer to the illustra-
tions below.
To reinstall, insert door hinges into frame openings. Open
oven door completely and rotate both hinge latches back to
the closed position.
OPEN
POSITION
CLOSED
POSITION
Oven door hinge latch.
|
8 Wolf Customer Care 800.222.7820
Door "at-rest" position.
Installation
Place the oven in the opening and slide back partially. Guide
the power cord through the opening of the adjacent cabinet
and slide oven back fully. Verify the power cord is not
trapped between the oven and cabinet wall.
Locate mounting holes on the oven side trim, two on each
side. Drill 1 / " pilot holes. Use the mounting screws pro-
16
vided to secure the oven to cabinetry. Refer to the illustra-
tion below.
To avoid interference, a 90° door stop may be required for
any appliance or cabinet door installed next to the oven.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
MOUNTING
HOLES
Oven installation.