Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using the Remote Control
4.2
Remote control trans-
ceiver PCB installation
Caution: For safety
reasons, disconnect
the power supply to
the
before
installation.
Pre-installation preparation
B Disconnect power supply to heater.
B Remove the mirror from the appli-
ance by pushing it lightly towards.
B Loosen the two screws.
Fig. 3
Remove front cover
4
water
heater
performing
B Open control box cover.
B Connect PCB's connection cable
as in Fig. 4.
Fig. 4
PCB connection cable
6 720 607 740
Publicité
Table des Matières
